Related Questions

A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
When creating a block the drafter needs to pay particular attention to selecting a base point because it determines the __________.
A Scale
B Rotation angle
C Insertion point
D Color
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
A Rotate the snap grid to the same angle of the inclined plane
B Offset the right vertical line of the front view
C Rotate the top line of the front view 45 degrees
D Offset the top line of the front view 2 inches
When a bar of length '$$l$$' and diameter 'd' is rigidly fixed at the upper end and hanging freely, then the total elongation produced in the bar due to its own weight is (where w = Weight per unit volume of the bar)
A $$\frac{{{\text{w}}l}}{{2{\text{E}}}}$$
B $$\frac{{{\text{w}}{l^2}}}{{2{\text{E}}}}$$
C $$\frac{{{\text{w}}{l^3}}}{{2{\text{E}}}}$$
D $$\frac{{{\text{w}}{l^4}}}{{2{\text{E}}}}$$
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
A Offset
B Half
C Whole
D Broken out
How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?
A Explode the dimension and then erase the center mark
B Use the Properties dialog box to turn off the center mark of the dimension
C It can't be done
D Use the trim tool to take away the stacked center mark
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
A Set the grid to isometric
B Set the current layer to Def-points
C Turn Object Snap off
D Turn Ortho off
An oil refinery relies on which type of drafter to maintain and update the technical piping drawings used for the construction and maintenance of the facility.
A Architectural
B Civil
C Process piping
D Electrical
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric
Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure that ________ is turned on.
A O Snaps
B Ortho
C Grid
D Dynamic Input

Next steps