Related Questions

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
Which of the following allows a router to respond to an ARP request that is intended for a remote host?
A Gateway DP
B Reverse ARP (RARP)
C Proxy ARP
D Inverse ARP (IARP)
Which of the following commands will configure all the default VTY ports on a router?
A Router#line vty 0 4
B Router (config) #line vty 0 4
C Router (config-if)#line console 0
D Router(config)#line vty all
Which of the following commands will allow you to set your Telnet password on a Cisco router?
A line telnet 0 4
B line aux 0 4
C line vty 0 4
D line con 0
Which of the following commands displays the configurable parameters and statistics of all interfaces on a router?
A show running-config
B show startup-config
C show interfaces
D show versions
Suppose that you have a customer who has a central HQ and six branch offices. They anticipate adding six more branches in the near future. They wish to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQ router. Which of the following would you recommend?
A PPP
B HDLC
C Frame Relay
D ISDN

Next steps