Related Questions

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
A frame-relay arp
B frame-relay map
C frame-relay interface-dci
D frame-relay lmi-type
ARP (Address Resolution Protocol) is
A a TCP/IP protocol used to dynamically bind a high level IP Address to a low-level physical hardware address
B a TCP/IP high level protocol for transferring files from one machine to another
C a protocol used to monitor computers
D a protocol that handles error and control messages
E None of the above
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
According to the passage, people respond to loud noises in the same way that they respond to
A annoyance
B damage
C danger
D disease
Which type of cable is used to connect the COM port of a host to the COM port of a router or switch?
A Crossover
B Straight-through
C Rolled
D none of these
Which type of cable is used to connect COM port of a host to the COM port a router or switch
A Crossover
B Straight -though
C Rolled
D Sheleded twisted pair

Next steps