Bissoy.com
Doctors Medicines MCQs Q&A

While using a meter bridge circuit a long signal difference is conditioned which might contain a compensating line to nullify the effect of long leads to the R.T.D.

While using a meter bridge circuit a long signal difference is conditioned which might contain a compensating line to nullify the effect of long leads to the R.T.D. Correct Answer False

This small signal difference is conditioned by utilizing a Wheatstone bridge circuit. A Resistance Temperature Detector is a device which utilized to determine the temperature by measuring the resistance of pure electrical wire. This wire is known as a temperature sensor. If we want to check temperature with high accuracy, R.T.D. is the only one sol. in industries.

Related Questions

When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?
A boat is on the one side of a bridge and the other boat is on the other side of the bridge. The bridge is 36 meter above the river surface. The angles of depression of both the boats from the bridge point on the bridge are complementary to each other and the angle of depression of first boat from the bridge is tan-1(1/3), then what is the distance between both the boats?
Select the option that is true regarding the following two statements labeled Assertion (A) and Reason (R). Assertion (A): Whenever we measure an electrical signal, there are chances of over current which leads to overheating of the meter. In such cases, the meter can be protected by using a semiconductor diode of suitable rating. Reason (R): As soon as the diode is short-circuited, the meter current is diverted through the diode. As a result, the meter is being protected from excess heating.
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
Four friends A, B, C and D need to cross a bridge. A maximum two persons can cross it at a time. It is night and they just have one lamp. Persons that cross the bridge must carry the lamp to find the way. A pair must walk together at the speed of slower person. After crossing the bridge, the person having faster speed in the pair will return with the lamp each time to accompany another person in the group. Finally, the lamp has to be returned at the original place and the person who returns the lamp has to cross the bridge again without lamp. To cross the bridge, the time taken by them is as follows: A :1 minute, B : 2 minutes, C : 7 minutes and D : 10 minutes. What is the total minimum time required by all the friends to cross the bridge?
A cow was standing on a bridge, 5m away from the middle of the bridge. A train was coming towards the bridge from the ends nearest to the cow. Seeing this cow ran towards the the train and managed to escape when the train was 2m away from bridge. If it had run in the opposite direction, it would hit by the train 2m before the end of the bridge. What is the lenght of the bridge in meters assuming the speed of the train is 4 times that of cow ?
In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
Consider the following threads, T1, T2, and T3 executing on a single processor, synchronized using three binary semaphore variables, S1, S2, and S3, operated upon using standard wait() and signal(). The threads can be context switched in any order and at any time. T1 T2 T3 While(true) { Wait(S3); Print(“C”); Signal (S2); } While(true) { Wait(S1); Print(“B”); Signal (S3); } While(true) { Wait(S2); Print(“A”); Signal (S1); }   Which initialization of the semaphores would print the sequence BCABCABCA….?
A middle school mathematics teacher distributes a piece of rope, 1 meter long, to her students. She asks them to make a list of things in their surroundings that are 1 meter long, slightly less or more than 1 meter, double or half of one meter. Which of the following statement(s) is/are true for the given situation? (a) It can be used as an activity to introduce standard unit of length measurement in a class. (b) It can be used to encourage children to estimate length of objects in daily life, (c) It is a good activity to establish the formula for conversion of metre to centimetre or vice-versa. (d) This type of activity should be given only as home task so that class time is utilised for solving the questions. Choose the correct option.
A 100-meter long train crosses a 200-meter long and 20-meter wide bridge in 20 seconds. What is the speed of the train in Km/hour?