What clearance should there be between the impeller and the backing plate?

Md Ariful Islam

0 like 0 dislike
1 views
Share with your friends

1 Answers

Dr. Md Rushad Rahman

Call

Look on the pump shaft, you usually can see the mark where the set screw was previously. Use the same mark.

1258 like 0 dislike
1 views
Talk Doctor Online in Bissoy App
I got cured from exfoliative cheilitis after seeing a Traditional Chinese medicine doctor. We did an intensive program of both acupuncture and lymphatic drainage massage, with herbal remedies, for 6 weeks. Is there a link between EC and the lymphatic system?

The etiology for EC is unknown. However I commend you for your persistence and working to find the cure for you. Thank you for your comment and the information. Best...

2 Answers 2 views
Why is the ball spun that way under #4? The animation between 4 and 5 is incorrect. The arrow shows an incorrect axis of rotation. The guy in the video below explains it correctly, but the arrow in the animation between 4 to 5 is going in the wrong direction. The ball should rotate clockwise as it goes down the lane, from the bowlers perspective, so the arrow should be pointing up. If the ball spun the way the animation shows, then it would be rotating on an axis perpendicular to the ground, which is not how it should be.

বিবাহপূর্ব।

2 Answers 1 views
If I am stuck in elevator and lights of the elevator are switched off, what should I do then? And whenever I go by lift I have fear of the lift getting stuck between floors. What should I do?

Having the lights go out probably adds to the fear about being stuck in an elevator. Use the light on your phone to illuminate the elevator buttons. See if there...

2 Answers 1 views
I need distinction between "media file" and "clip". I expect several clips from each file to be listed in a clip bin, not a media bin. And to be selectable there for adding to timeline.

A clip is a section of video or audio from a film or audio track whereas a media file is an overall description of any item that comes under the...

2 Answers 1 views
This two piece split bamboo fly rod has part of a label still in it. I can see the last three letters of a word gue, and another word of "harbor". There is a fish with green on the gill plate and red behind the figure and the handle is wood and the guides and ferrule are brass. What is this?

That's a saltwater boat rod, not a fly rod. It was produced by Montague and sold as the Stone Harbor model.

2 Answers 1 views
Should I use a glass pie plate or an aluminum pie plate when using the baked quiche method?

Either one. Just remember not to thaw before reheating to keep the crust from getting soggy.

2 Answers 1 views
My trunk is locked and I have no key. There is no fob or inside trunk release, and I cannot get through the back seat, as there is a solid brace blocking it off. What should I do?

Take the car to a shop. Or, try unscrewing the tail light and using a strong wire to open the latch.

2 Answers 1 views
What is the clearance between the bearing and the shaft? Should it be size on size or a couple thousandths clearance?

If it is a split Babbitt, you will have a gasket between the two halves that allow for tightening due to wear. The procedure pretty much leaves it size to...

2 Answers 1 views
How do I change my shop name on Etsy? There should be a space between words, and it won't let me.

Etsy does not allow spaces between words in the shop name. To change your name, from your dashboard page over in the left hand column click on "Settings". Click on...

2 Answers 1 views