What is the clearance between the bearing and the shaft? Should it be size on size or a couple thousandths clearance?

Md Ariful Islam

0 like 0 dislike
1 views
Share with your friends

1 Answers

Dr. Md Rushad Rahman

Call

If it is a split Babbitt, you will have a gasket between the two halves that allow for tightening due to wear. The procedure pretty much leaves it size to size. After you cut the grooves and put it together, it is recommended to grease or oil it up and run it with a small electric motor and belt to wear it in for 24 - 48 hours, which allows you to check for excess heat, and general operating soundness.

1268 like 0 dislike
1 views
Talk Doctor Online in Bissoy App
Why is the ball spun that way under #4? The animation between 4 and 5 is incorrect. The arrow shows an incorrect axis of rotation. The guy in the video below explains it correctly, but the arrow in the animation between 4 to 5 is going in the wrong direction. The ball should rotate clockwise as it goes down the lane, from the bowlers perspective, so the arrow should be pointing up. If the ball spun the way the animation shows, then it would be rotating on an axis perpendicular to the ground, which is not how it should be.

বিবাহপূর্ব।

1 Answers 1 views
If I am stuck in elevator and lights of the elevator are switched off, what should I do then? And whenever I go by lift I have fear of the lift getting stuck between floors. What should I do?

Having the lights go out probably adds to the fear about being stuck in an elevator. Use the light on your phone to illuminate the elevator buttons. See if there...

1 Answers 1 views
What if I want to dye the shaft?

You cannot dye a shaft, as most lacrosse shafts are made out of metal.

1 Answers 1 views
Couldn't I just type in a couple commands like '/gamerule keepInventory true' and '/kill' or just change to creative mode and fly out?

You could do that, but some players don't play with cheats and would rather find a way out that doesn't involve cheating. It can sometimes be more enjoyable trying to...

1 Answers 1 views
Can Babbit be used to fill between a worn shaft spline?

Due to Babbit's inherent softness compared to the metallurgy required for shafting applications, I would not recommend it.

1 Answers 1 views
What clearance should there be between the impeller and the backing plate?

Look on the pump shaft, you usually can see the mark where the set screw was previously. Use the same mark.

1 Answers 1 views
How do I replace the crank shaft pulley?

It's impossible to say without knowing the year, make, or model of your vehicle. You should be able to do a search online to find some tips on replacing parts...

1 Answers 1 views