বাংলাদেশ এ tp link router পার্স পাতি কথায় পাওয়া যায় ও ঢাকায় কথায় service centre ase
Answer: Option 3 The typical banner is a message of the day (MOTD) and is set by using the global configuration mode command banner motd.
1 Answers 1 viewsAnswer: Option 2 When a routing update is received by a router, the router first checks the administrative distance (AD) and always chooses the route with the lowest AD. However,...
1 Answers 1 viewsAnswer: Option 1 Clocking on a serial interface is always provided by the CSU/DSU (DCE device). However, if you do not have a CSU/DSU in your nonproduction test environment, then...
1 Answers 1 viewsAnswer: Option 1 By default, all VLANs are allowed on the trunk link and you must remove by hand each VLAN that you don't want traversing the trunked link.
1 Answers 3 viewsAnswer: Option 4 Cisco routers, if they do not have the Enterprise edition of the IOS, will default to 5 simultaneous Telnet sessions.
1 Answers 1 viewsAnswer: Option 1 If you have a serial port configured with multiple DLCIs connected to multiple remote sites, split horizon rules, stop route updates received on an interface from being...
1 Answers 1 viewsAnswer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 viewsAnswer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 viewsAnswer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 viewsAnswer: Option 2 At the moment of OSPF process startup, the highest IP address on any active interface will be the Router ID (RID) of the router. If you have...
1 Answers 5 views