- By default, all VLANs are allowed on the trunk.
- No VLAN's are allowed, you must configure each VLAN by hand.
- Only configured VLAN's are allowed on the link.
- Only extended VLAN's are allowed by default.
Answer: Option 3 Let'
1 Answers 1 viewsAnswer: Option 2 When a routing update is received by a router, the router first checks the administrative distance (AD) and always chooses the route with the lowest AD. However,...
1 Answers 1 viewsAnswer: Option 3 It is very important to remember when studying the CCNA exam objectives, and when configuring Frame Relay with point-to-point subinterfaces, that you do not put an IP...
1 Answers 2 viewsAnswer: Option 3 Let'
1 Answers 2 viewsAnswer: Option 1 If you have a serial port configured with multiple DLCIs connected to multiple remote sites, split horizon rules, stop route updates received on an interface from being...
1 Answers 1 viewsAnswer: Option 4 Let'
1 Answers 1 viewsAnswer: Option 3 Since the source MAC address is not in the MAC address table, the switch will add the source address and the port it is connected to into...
1 Answers 1 viewsAnswer: Option 2 The show flash command will provide you with the current IOS name and size and the size of flash memory.
1 Answers 5 viewsAnswer: Option 4 This question is a little vague, but the best answer is that the VLAN membership for the port is not configured.
1 Answers 1 views