Bissoy.com
Doctors Medicines MCQs Q&A

A suspension bridge with a two-hinged stiffening girder is

A suspension bridge with a two-hinged stiffening girder is Correct Answer Indeterminate of one degree

A suspension bridge with a two-hinged stiffening girder is statically indeterminate of one degree.

A suspension bridge with a three-hinge stiffening girder is statically determinate.

Related Questions

Consider the following statements regarding suspension cables: 1) The horizontal component of the cable tension in a suspension bridge is constant at every point along the length of the cable 2) Stiffening girders in a suspension bridge carry only the live load Which of the above statements is/are correct?
When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?
The suspension bridges require a stiffening girder for covering the span, with a __________
Four friends A, B, C and D need to cross a bridge. A maximum two persons can cross it at a time. It is night and they just have one lamp. Persons that cross the bridge must carry the lamp to find the way. A pair must walk together at the speed of slower person. After crossing the bridge, the person having faster speed in the pair will return with the lamp each time to accompany another person in the group. Finally, the lamp has to be returned at the original place and the person who returns the lamp has to cross the bridge again without lamp. To cross the bridge, the time taken by them is as follows: A :1 minute, B : 2 minutes, C : 7 minutes and D : 10 minutes. What is the total minimum time required by all the friends to cross the bridge?
A boat is on the one side of a bridge and the other boat is on the other side of the bridge. The bridge is 36 meter above the river surface. The angles of depression of both the boats from the bridge point on the bridge are complementary to each other and the angle of depression of first boat from the bridge is tan-1(1/3), then what is the distance between both the boats?
A cow was standing on a bridge, 5m away from the middle of the bridge. A train was coming towards the bridge from the ends nearest to the cow. Seeing this cow ran towards the the train and managed to escape when the train was 2m away from bridge. If it had run in the opposite direction, it would hit by the train 2m before the end of the bridge. What is the lenght of the bridge in meters assuming the speed of the train is 4 times that of cow ?
The sleepers resting directly on girder are fastened to the top flange of girder by
Consider the following statements: 1. The thickness of the gusset plate should not be more than the thickness of the structural members being connected. 2. A plate girder is essentially a beam and its moment of resistance depends upon its section modulus. 3. The function of the flanges in a plate girder is to resist the bending moment and hence their respective areas can be reduced near the supports of a simply supported beam. Which of the above statements are correct?
Why plate girder is preferred over truss girder?
Match List I (Bridges) with List – II (Quantity measured) and select the correct answer using the codes given below the lists: List - I List - II A. Anderson Bridge i. Frequency B. Kelvin Double Bridge ii. Resistance C. Schering Bridge iii. Inductance D. Wien Bridge iv. Capacitance