Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
Below stated are some of the statements about the Alternating current. You need to identify which of the following is incorrect, 1. DC power is far more powerful than AC power. The efficiency and power to size characteristics of DC motors and apparatuses are increased. Lighting by DC (LED) is 75% more efficient than lighting from incandescence. 2. A comparatively high voltage alternating current may be generated and easily raised and dropped by the static equipment known as the transformer, which makes electrical energy transmission and distribution economical, 3. Initial costs and maintenance of the AC motor are less expensive since it has no switch and is less powerful than the DC motor for constant working speed, hence it is desired to create power as alternating current. 4. The great efficiency of transmission in ac makes electric power generation cost-effective, Produced in huge quantities in one station and distributed throughout a vast area.
Alternating current cannot be measured by DIRECT CURRENT ammeter because
Consider the following statements regarding reciprocity theorem : 1. In any passive linear bilateral network, if the single voltage source Vx, in branch x produces the current response Iy, in branch y, then the removal of the voltage source from branch x and its insertion in branch y will produce the current response iy in branch x. 2. The interchange of an ideal voltage source and an ideal ammeter in any passive, linear, bilateral circuit will not change the ammeter reading. 3. The interchange of an ideal current source and an ideal voltmeter in any passive linear bilateral circuit will change the voltmeter reading. Which of the above statements are correct ?
Which one of the devices changes low voltage alternating current to high voltage alternating current and vice versa?
Which one of the following devices changes low voltage alternating current to high voltage alternating current and vice-versa?
সিরিজে সংযুক্ত একটি এ্যামিটার এবং একটি অজানা রোধ দুটি একই রকম 1.5 V ব্যাটারীর দুই প্রান্তে সংযুক্ত আছে। যখন ব্যাটারী দুটি সিরিজে সংযুক্ত থাকে তখন এ্যামিটার। amp রিডিং প্রদর্শন করে। আবার ব্যাটারী দুটি সমান্তরালে সংযুক্ত করলে 0.6 amp রিডিং প্রদর্শন করে। ব্যাটারীর আভ্যন্তরিন রোধ কত ? (An ammeter and an unknown resistance are connected in series across two identical batteries of each 1.5 V. The ammeter shows current I amp and 0.6 amp when the batteries are connected in series and parallel, respectively. What is the internal resistance of the battery?)
The current passing through a galvanometer is 30 mA, resistance of the galvanometer is 50 Ω and a shunt is 1 Ω is connected to the galvanometer. What is the maximum current that can be measured by this ammeter?
A metal wire of linear mass density of 9.8/gm is stretched with a tension of 10kg wt between two rigid supports 1m apart. The wire passes at its middle point between the poles of a permanent magnet and it vibrates in resonance, when carrying an alternating current of frequency v. The frequency v of the alternating source is?
An ammeter has a resistance of G ohms and range of I amperes. The value of resistance required in parallel to convert it into an ammeter of range nI is ___________.