Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which one of the devices changes low voltage alternating current to high voltage alternating current and vice versa?
Below stated are some of the statements about the Alternating current. You need to identify which of the following is incorrect, 1. DC power is far more powerful than AC power. The efficiency and power to size characteristics of DC motors and apparatuses are increased. Lighting by DC (LED) is 75% more efficient than lighting from incandescence. 2. A comparatively high voltage alternating current may be generated and easily raised and dropped by the static equipment known as the transformer, which makes electrical energy transmission and distribution economical, 3. Initial costs and maintenance of the AC motor are less expensive since it has no switch and is less powerful than the DC motor for constant working speed, hence it is desired to create power as alternating current. 4. The great efficiency of transmission in ac makes electric power generation cost-effective, Produced in huge quantities in one station and distributed throughout a vast area.
Two involute gears are designed to mesh for a given centre distance and a given angular velocity ratio (other than 1). During assembly, the centre distance has increased slightly. Then which of the following changes occur? (i) Velocity ratio changes (ii) Pressure angle changes (iii) Pitch circle diameter changes (iv) Working depth changes (v) Base circle radius changes Select the correct answer using the code given below.
The influence of shape of aggregate in strength and workability of concrete are given below in statements S1, S2, S3 and S4. Which of the statements are correct? S1: Rounded aggregate produces concrete with high workability and low strength. S2: Angular aggregate produces concrete with high workability and low strength. S3: Rounded aggregate produces concrete with low workability and high strength. S4: Angular aggregate produces concrete with low workability and high strength.
For an instrumentation amplifier, the following parameters are given (a) High input resistance and low power consumption (b) Low input resistance and low power consumption (c) High CMRR and high slew rate (d) Low CMRR and high slew rate Which of the given parameters are a major requirement for an instrumentation amplifier?
Which of the following materials is best suited to make a fuse wire? Material Melting Point Resistivity X High Low Y High High Z Low High W Low Low
In the following question, sentences of a paragraph have been jumbled and labelled as A, B, C and D. You are required to rearrange the jumbled sentences of the paragraph and mark your response accordingly by selecting the correct option. A: Transformers can also be used for isolation, where the voltage in equals the voltage out, with separate coils not electrically bonded to one another. B: Transformers are most commonly used for increasing low AC voltages at high current (a step-up transformer) or decreasing high AC voltages at low current (a step-down transformer) in electric power applications. C: It was discovered in 1831. D: A transformer is a passive electrical device that transfers electrical energy from one electrical circuit to another.
Arrange the following demographic transition theory given by Blackur (ascending order)
1. Declining phase with low mortality, lower fertility
2. Low stationary phases with low fertility and low mortality
3. Early expanding phase marked by high fertility
4. High stationary phase marked by high fertility and mortality
S1: Different countries show different pattern of growth.
P: Many others have a high birth rate with a low death rate.
Q: Some have a high birth rate and still have a high death rate.
R: The developing countries show the most rapid growth rate.
S: Some others like the European nations, have a low birth rate and a low death rate.
S6: Compared to this in Europe the growth rate is low.

The Proper sequence should be:
Mundel's classes of change includes
1. Changes in body motions and positions
2. Changes in equipment and working arrangements
3. Changes in production sequence
4. Changes in finished product
5. Changes in raw material