Related Questions

If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.
A 40%
B 50%
C 60%
D 70%
Minimum pitch of transverse reinforcement in a column is
A The least lateral dimension of the member
B Sixteen times the smallest diameter of longitudinal reinforcement bar to be tied
C Forty-eight times the diameter of transverse reinforcement
D Lesser of the above three values
The transverse reinforcements provided at right angles to the main reinforcement
A Distribute the load
B Resist the temperature stresses
C Resist the shrinkage stress
D All the above
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
A 4 mm
B 5 mm
C 6 mm
D 7 mm
Minimum spacing between horizontal parallel reinforcement of the same size should not be less than
A One diameter
B 2.5 diameters
C 3 diameters
D 3.5 diameters
Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than
A One diameter of thinner bar
B One diameter of thicker bar
C Twice the diameter of thinner bar
D None of these
According to Euler's column theory, the crippling load for a column of length (l) fixed at both ends is __________ the crippling load for a similar column hinged at both ends.
A Equal to
B Two times
C Four times
D Eight times
-Column row+Column row+Column row এই ফরমূলা কিসের?
A ভাগ এর
B যোগ এর
C গুণ এর
D বিয়োগ এর
The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle θ° with horizontal where θ° is
A 30°
B 45°
C 60°
D None of these
ACI Code অনুসারে Column এর Minimum longitudinal reinforcement কত?
A ০.৫%
B ১%
C ২%
D ৩%

Next steps