Related Questions

If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.
A 40%
B 50%
C 60%
D 70%
Steel rods are normally used for concrete reinforcement because concrete and steel have almost equal
A Tensile strength
B Compressive strength
C Young's modulus
D Thermal co-efficient of expansion
three meauring rods are 64 cm, 80 cm and 96 cm in length, What is the least length of cloth that can be measured exact number of times using any one of these rods ?
A 9.60 m
B 8,0 m
C 9.60 cm
D 96m
Three measuring rods are 64 cm, 80 cm and 96 cm in length. what is the least length of cloth that can be measured exact number of times using any one of these rods?
A 9.60 m
B 8.0 m
C 9.60 cm
D 96 m
The transverse reinforcements provided at right angles to the main reinforcement
A Distribute the load
B Resist the temperature stresses
C Resist the shrinkage stress
D All the above
The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than
A 18 bar diameters
B 24 bar diameters
C 30 bar diameters
D 36 bar diameters
Minimum pitch of transverse reinforcement in a column is
A The least lateral dimension of the member
B Sixteen times the smallest diameter of longitudinal reinforcement bar to be tied
C Forty-eight times the diameter of transverse reinforcement
D Lesser of the above three values
The spacing of transverse reinforcement of column is decided by the following consideration.
A The least lateral dimension of the column
B Sixteen times the diameter of the smallest longitudinal reinforcing rods in the column
C Forty-eight times the diameter of transverse reinforcement
D All the above
P,Q,R and S are four men , p is the oldest but not the poorest. R is the richest but not the oldest. Q is older than S but not than P or R, P is richer than Q but not than S .The four men can be ordered descending in respectof age and richness respectively, as
A PQRS ,RPSQ
B PRQS, RSPQ
C PRQS, RSQP
D PRSQ, RSPQ
The diameter of main bars in R.C.C. columns, shall not be less than
A 6 mm
B 8 mm
C 10 mm
D 12 mm

Next steps