Related Questions

If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.
A 40%
B 50%
C 60%
D 70%
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
A 4 mm
B 5 mm
C 6 mm
D 7 mm
If the sum of two adjacent angles is equal to two right angles, then the two angles are ----
A adjacent angles
B straight angles
C supplementary angles
D condemnatory angles
Minimum pitch of transverse reinforcement in a column is
A The least lateral dimension of the member
B Sixteen times the smallest diameter of longitudinal reinforcement bar to be tied
C Forty-eight times the diameter of transverse reinforcement
D Lesser of the above three values
The spacing of transverse reinforcement of column is decided by the following consideration.
A The least lateral dimension of the column
B Sixteen times the diameter of the smallest longitudinal reinforcing rods in the column
C Forty-eight times the diameter of transverse reinforcement
D All the above
In a counterfort retaining wall, the main reinforcement in the stem at mid span is provided on
A Front face only
B Inner face only
C Both front face and inner face
D None of the above
The main reinforcement in the heel of a T-shaped R.C. retaining wall is provided on
A Top face perpendicular to wall
B Bottom face perpendicular to wall
C Both top and bottom faces perpendicular to wall
D None of the above
The portion of a brick cut to form angles other than right angles in plan, is known as
A Queen closer
B King closer
C Closer
D Squint brick
Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle?
A Segmental baffle
B Flat plate extending across the wall
C Disk type baffle
D Helical type baffle
Distribution reinforcement in a simply supported slab, is provided to distribute
A Load
B Temperature stress
C Shrinkage stress
D All the above

Next steps