Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.
A cable sequence
B jumpers on the hard drive
C drivers that need to be loaded
D hard drive manufacturer web site information
E None of the above
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
A C
B D
C E
D F
E None of the above
In case of wet spinning of polymers, the polymer solution is forced through spinnerates into, a coagulating bath to give a filament form. Wet spinning is not used in case of the __________ fibres.
A Viscose rayon
B Acrylic
C Polyvinyl acetate
D Saturated polyester
Melt spinning of polymers involves the forcing of polymer melt through spinnerettes (fine holes) into an atmosphere kept at a temperature lower than the melting point of the polymer, which causes the fine diameter polymer melt to harden into filaments. Melt spinning is not used in case of the __________ fibres.
A Acrylic
B Polyester
C Nylon 6:6
D Polypropylene
Your PC tells you that your 200 M hard drive is out of space . However , when you run DIR .the total size of your files add to less than 200 M. How do you account for this difference ?
A Rounding
B Hidden files
C Math error
D Drive specifications are in hexadecimal , whereas the DIR Command calculates decimal
In case of dry spinning of polymers, the polymer solution in a volatile solvent is forced through the spinnerates into a warm air chamber, where the solvent evaporates leaving behind the polymer in the filament form. Dry spinning is used for __________ fibres.
A Polythene
B PVC
C Rayon
D Polyvinyl acetate
stand next to the lamppost and face west ,walk 20 yards and then turn 90 degrees clockwise. Walk another 10 yards and then turn 45 degrees anticlockwise. Walk another 15 yards, reverse you direction and walk 5 yards back. Turn 135 degrees clockwise and walk another 10 yards . In which direction are you now facing?
A West
B East
C South
D North
Leave Interstate 25 at exit 7S. Follow that road (Elm Street) for two miles. After one mile, you will pass a small shopping centre on your left. At the next next set of traffic lights, turn right onto Maple Drive. Erik's house is the third house on your left. It's number 33, and it's white with green trim. Select the best answer: Which is closest to Erik's house?
A the traffic lights
B the shopping center
C exit 7S
D a green house

Next steps