Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
A C
B D
C E
D F
E None of the above
Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.
A bad data cable
B incorrect jumper setting on drive
C loose molex connector
D virus
E tfad system board
A workstation has just been installed on an Ethernet LAN, but cannot communicate with the network. What should you check first?
A reinstall the network protocols
B reinstall the network interface card driver
C verify the ip configuration on the workstation
D verify the link status on the computer's network card
E None of the above
A customer has just installed a new cd-rw. the system was working fine before the installation, but now the cdrom does not work, what should you suggest that the customer do?
A flash or upgrade the BIOS
B check the CONFIG.SYS
C add cdrw in the device manager
D check the jumper setting on the cd-rw
E None of the above
Your PC tells you that your 200 M hard drive is out of space . However , when you run DIR .the total size of your files add to less than 200 M. How do you account for this difference ?
A Rounding
B Hidden files
C Math error
D Drive specifications are in hexadecimal , whereas the DIR Command calculates decimal
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
A The port speed is set too high
B the modem has not been set up in control panel properties
C the phone line is plugged into the line-in port on the modem card
D the phone line out of the wall is plugged into the phone port on the modem card
E None of the above
What is your first action when windows reports that your hard drive is developing bad sectors?
A replace the hard drive
B run secclean from dos
C run defrag on the hard drive
D run scandisk with the "thorough" option
E None of the above
When connecting two internal SCSI hard disks to a computer, where do you connect the second hard drive?
A Any open SCSI port on the computer
B A Serial port on the first host adapter
C An open parallel port on the computer
D An open SCSI port on the first hard drive
E None of the above

Next steps