You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format

Correct Answer: jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch

Bissoy MCQ
#Computer Science #Computer Hardware

Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.
A cable sequence
B jumpers on the hard drive
C drivers that need to be loaded
D hard drive manufacturer web site information
E None of the above
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
A C
B D
C E
D F
E None of the above
Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.
A bad data cable
B incorrect jumper setting on drive
C loose molex connector
D virus
E tfad system board
You see the message "invalid media device" after installing a new hard drive. What do you do next?
A Format
B Fdisk
C Partition
D Add the OS
E None of the above
Your PC tells you that your 200 M hard drive is out of space . However , when you run DIR .the total size of your files add to less than 200 M. How do you account for this difference ?
A Rounding
B Hidden files
C Math error
D Drive specifications are in hexadecimal , whereas the DIR Command calculates decimal
Mr. Ali decided to walk down the escalator of a tube station. He found that if he walks down 26 steps, he requires 30 seconds to reach the bottom. However, if he steps down 34 stairs he would only require 18 seconds to get to the bottom. If the time is measured from the moment the top step begins to descend to the time he steps off the last step at the bottom, find out the height of the stair way in steps?
A 23 steps
B 16 steps
C 46 steps
D 26 steps
Hard disk এর পিছনের জাম্পার সেটিং ঠিক না থাকলে যে সমস্যা হয় -i. সফটওয়্যার install করা যায় নাii. Boot disk failureiii. Hard disk not found দেখায়নিচের কোনটি সঠিক?
A i ও ii
B i ও iii
C ii ও iii
D i, ii ও iii
Boot disk failure দেখায় কারণ-i. র্যাম এ সমস্যা হলেii. Hard disk drive ডিটেক্ট করা না গেলেiii. জাম্পার সেটিং সঠিকভাবে না হলেনিচের কোনটি সঠিক?
A i ও ii
B i ও iii
C ii ও iii
D i, ii ও iii
After you have compiled your kernel, what do you have to edit to boot your new kernel image?
A /boot/lilo.conf
B /etc/conf.modules
C /etc/named.boot
D /etc/lilo.conf
E None of the above

Next steps