Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The pie chart given below shows the amount spent by a boy on the purchase of six different items. The total amount spent on all these six items is Rs. 54000. The amount spent on a specific item is represented as a degree with reference to the total amount spent on all these six items. Which of the following statement(s) is/are correct? I. The amount spent on article A is Rs.900 less than the amount spent on article B. II. The amount spent on article C is Rs 2400 more than the amount spent on article D. III. The ratio of the amount spent on article B to the amount spent on article E is 4 : 1.
Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
In compound rest method, the amount of taper for setting the angle is calculated from this formula, tan of angle of taper =_____
Each of the question below consists of a question and three statements number I, II and III given below it. You have to decide whether the data provided in the statement are sufficient to answer the question. Sid has a monthly income of Rs. 60000 out of which every month he saves some amount. He distributes some amount of money among his three sisters and one brother. Out of remaining amount of his income, he spends 40% on other things and rest of the amount is saved by him. What percent of money is received by each sister if each sister receives equal amount? Statement I: Each sister received Rs. 500 less than the amount received by brother and Sid’s other expenditure is Rs. 16800. Statement II: Sid saves Rs. 25200 on every month. Statement III: Each sister and brother received equal amount and saving are Rs. 25200.
In standard taper roller bearings, the angle of taper of outer raceway is
A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of taper gradient for a job of 1m in length?
What is the error for the true running of spindle taper for machines with taper larger than Morse No. 2?
Full taper angle is also known as angle of taper.
The taper can be turned up to maximum setting angle of_____ for both outside and inside tapers with taper attachment and automatic feed.