Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
In compound rest method, the amount of taper for setting the angle is calculated from this formula, tan of angle of taper =_____
Which three statements are true about the operation of a full-duplex Ethernet network?
1. There are no collisions in full-duplex mode.
2. A dedicated switch port is required for each full-duplex node.
3. Ethernet hub ports are preconfigured for full-duplex mode.
4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
5. The host network card and the switch port must be capable of operating in full-duplex mode.
In standard taper roller bearings, the angle of taper of outer raceway is
The taper can be turned up to maximum setting angle of_____ for both outside and inside tapers with taper attachment and automatic feed.
Angle ‘A’ of a cyclic quadrilateral ABCD is 53° less then angle B. Angle B is twice of angle C and angle C is 40° more than angle D. What would be the measure of angle A?
The charges for a five-day trip by a tourist bus for one full ticket and a half-ticket are Rs. 1440 inclusive of boarding charges which are same for a full ticket and a half-ticket. The charges for the same trip for 2 full tickets and one half-ticket inclusive of boarding charges are Rs. 2220. The fare for a half-ticket is 75% of the full ticket. Find the fare and the boarding charges separately for one full ticket.
A displacement sensor (a dial indicator) measures the lateral displacement of a mandrel mounted on the taper hole inside a drill spindle. The mandrel axis is an extension of the drill spindle taper hole axis and the protruding portion of the mandrel surface is perfectly cylindrical measurements are taken with the sensor placed at two positions P and Q as shown in the figure. The readings are recorded as Rx = maximum deflection minus minimum deflection, corresponding to sensor position at X, over one rotation. If RP = RQ > 0, which one of the following would be consistent with the observation?
During taper turning operation 100mm of smaller side diameter and 800mm of bigger side diameter was required. What will be the value of taper gradient for a job of 1m in length?
What is the error for the true running of spindle taper for machines with taper larger than Morse No. 2?