Bissoy.com
Doctors Medicines MCQs Q&A

The taper can be turned up to maximum setting angle of_____ for both outside and inside tapers with taper attachment and automatic feed.

The taper can be turned up to maximum setting angle of_____ for both outside and inside tapers with taper attachment and automatic feed. Correct Answer 10 to 12 degree

The taper can be turned up to maximum setting angle of 10 to 12 degree for both outside and inside tapers with taper attachment and automatic feed.

Related Questions

Which of the following option is correct for given statements about plug gauges for self-holding tapers? Statement 1: Plug is inserted with high pressure for checking taper. Statement 2: Morse taper is a type of self-holding taper.
Saurabh went in his car to his coaching centre. He drove 30 m towards North and then turned to his left and moves 40 m. He then turned to left and covered 80 m. Further he turned to his left and moved 50 m. Finally he turned left and drove 10 m and then turned left to travel 10 m. How far is he from the starting point?
Consider the following statements regarding 'setting of cement': 1. Low-heat cement sets faster than OPC. 2. Final setting time decides the strength of cement. 3. Initial setting time of Portland PozzoIlona is 30 minutes. 4. Air-induced setting is observed when stored under damp conditions. 5. Addition of gypsum retards the setting time. Which of the above statements are correct?
Two pipes A and B can fill an empty cistern in 4.8 and 7.2 hours, respectively. Pipe C can drain the entire cistern in 9.6 hours when no other pipe is in operation. Initially when the cistern was empty, Pipe A and Pipe C were turned on. After a few hours, Pipe A was turned off and Pipe B was turned on instantly. In all it took 16.8 hours to fill the cistern. For how many hours was Pipe B turned on?
Two pipes A and B can fill an empty cistern in 18 and 27 hours respectively. Pipe C can drain the entire cistern in 45 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few hours Pipe A was turned off and Pipe B was turned on instantly. In all, it took 55 hours to fill the cistern. For how many hours was Pipe B turned on?
Two pipes A and B can fill an empty cistern in 32 and 48 hours, respectively. Pipe C can drain the entire cistern in 64 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few hours. Pipe A was turned off and Pipe B was turned on instantly. In all it took 112 hours to fill the cistern. For how many hours was Pipe B turned on?
Two pipes A and B can fill an empty cistern in 18 and 27 hours, respectively. Pipe C can drain the entire cistern in 45 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few Pipe A was turned off and Pipe B was turned on instantly. In all, it took 55 hours to fill the cistern. For how many hours was Pipe B turned on?
In compound rest method, the amount of taper for setting the angle is calculated from this formula, tan of angle of taper =_____
By attachment method, large number of taper angle can be turned.
Study the following information carefully and answer the question based on it. I was facing west. I turned right and walked 7 km, then turned left and walked 12 km. I again turned right and walked 5 km. After walking 5 km, I again turned right and 12 km. How much is the total distance travelled?