Related Questions

The ideal efficiency of a Brayton cycle without regeneration, with increase in pressure ratio will
A Increase
B Decrease
C Remain unchanged
D Increase/decrease depending on application
The ideal efficiency of a Brayton cycle with regeneration, with increase in pressure ratio will
A Increase
B Decrease
C Remain unchanged
D Increase/decrease depending on application
Heat evolved/absorbed during conversion of a substance from one allotropic form to another is termed as the heat of
A Fusion
B Vaporisation
C Transition
D None of these
The C.O.P. of a heat pump working on a reversed Carnot cycle is
A $$\frac{{{{\text{T}}_1}}}{{{{\text{T}}_2} - {{\text{T}}_1}}}$$
B $$\frac{{{{\text{T}}_2} - {{\text{T}}_1}}}{{{{\text{T}}_1}}}$$
C $$\frac{{{{\text{T}}_1} - {{\text{T}}_2}}}{{{{\text{T}}_1}}}$$
D $$\frac{{{{\text{T}}_2}}}{{{{\text{T}}_2} - {{\text{T}}_1}}}$$
A refrigeration cycle is a reversed heat engine. Which of the following has the maximum value of the co-efficient of performance (COP) for a given refrigeration effect?
A Vapor compression cycle using expansion valve
B Air refrigeration cycle
C Vapor compression cycle using expansion engine
D Carnot refrigeration cycle
In which of the waste heat recovery equipment, the flow of flue gas and air is alternately reversed after a fixed interval of time?
A Recuperator
B Regenerator
C Waste heat boiler
D None of these
Otto cycle efficiency is higher than Diesel cycle efficiency for the same compression ratio and heat input because in Otto cycle
A Heat rejection is lower
B Expansion and compression are isentropic
C Combustion is at constant volume
D Maximum temperature is higher
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
একটি কর্নো ইঞ্জিন 500 K এবং 205 K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে 1 kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250K. If the engine receives 1 kcal of heat from the source in each cycle, the amount of heat rejected to the sink in each cycle is-)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal
একটি কার্নো ইঞ্জিন 500K এবং 250K তাপমাত্রার দুইটি আধারের মাধ্যমে পরিচালিত হয়। প্রত্যেক চক্রে ইঞ্জিন যদি উৎস থেকে । kcal তাপ গ্রহণ করে তাহলে প্রত্যেক চক্রে তাপ গ্রাহকে তাপ বর্জন করার পরিমাণ কত? ( A Carnot engine is operated between two reservoirs at temperatures of 500 K and 250 K. If the engine receives 1 kcal of heat from the source in cach cycle, the amount of heat rejected to the sink in each cycle is --)
A 500 cal
B 1000 cal
C 500 kcal
D 10 kcal

Next steps