Related Questions

Rashna Company collected the following data in its accounting records in 2014 : From the income statement : Depreciation expense Tk. 1,000 Loss on sale of equipment 3,000 From the comparative balance sheet : Beginning balance , equipment Tk. 12,500 Ending balance , equipment 8,000 Beginning balance , accumulated depreciation 2,000 Ending balance , accumulated depreciation 2,400 No new equipment was purchased during the year. The equipment was sold at the end of the year. What was the cash in -flow from the sale of equipment in 2014?
A Tk, 3,900
B Tk. 1,000
C Tk. 900
D Tk. 600
Thermal conductivity based continuous flue gas analyser makes use of varying thermal conductivity of the constituents of flue gases. Which of the following constituents of flue gases has the maximum thermal conductivity?
A CO2
B N2
C O2
D CO
Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace?
A Economiser
B Regenerator
C Ceramic recuperator
D Waste heat boiler
Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ °C, because corrosion prevails at higher temperatures.
A 350
B 750
C 1050
D 1250
Ceramic recuperators used for waste heat recovery from high temperature flue gas going out of the furnace is made of
A Fireclay
B Silicon carbide
C Corrundum
D Siliceous fireclay
The ratio of the energy required to produce the artificial draught (expressed in meters head or J/kg of flue gas) to the mechanical equivalent of extra heat carried away per kg of flue gases due to natural draught, is known as
A Efficiency of the boiler
B Efficiency of the chimney
C Efficiency of the fan
D Power of the boiler
A device in which some portion of waste heat of flue gases is recovered to heat the air before it passes to the furnace for combustion purpose, is known as
A Superheater
B Air-preheater
C Economizer
D Injector
Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the
A Quantity & temperature of waste gas
B Dust concentration & nature of dust in waste gas
C Corrosive nature of the waste gas
D All of the above
In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A Convection
B Radiation
C Conduction
D Both convection and conduction
Most efficient and suitable dust removal equipment for removal of flyash from flue gas in a thermal power plant is the
A Gravity settling chamber
B Cyclone separator
C Electrostatic precipitator
D Bag filter

Next steps