Related Questions

The flank of the tooth is the surface of the tooth __________ the pitch surface.
A Above
B Below
C At
D None of these
A certain dentist specializes in implanting gold and silver teeth in his patients mouths .He charges $ 650 for a gold tooth an $ 325. for a silver tooth. If his told fees for implanting gold and silver teeth last week were $ 15, 925 in total and he implanted five more gold teeth that silver teeth, how many teeth in total did he implant over the week?
A 33
B 32
C 31
D 34
The radial distance of a tooth from the pitch circle to the bottom of the tooth is called
A dedendum
B addendum
C clearance
D working depth
The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called
A dedendum
B addendum
C clearance
D working depth
In _________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.
A Up milling
B Down milling
C Face milling
D End milling
The difference between the tooth space and the tooth thickness as measured on the pitch circle, is called
A Working depth
B Clearance
C Backlash
D Face width
The radial distance of a tooth from the pitch circle to the top of the tooth is called
A Addendum
B Dedendum
C Clearance
D Working depth
In a plain milling cutter, the chip space between the back of one tooth and the face of the next tooth is called
A Face
B Fillet
C Gash
D Land
Flank wear depends upon the
A hardness of the work and tool material at the operating temperature
B amount and distribution of hard constituents in the work material
C degree of strain hardening in the chip
D none of the mentioned
Flank wear occurs mainly on the
A nose part, front relief face and side relief face of the cutting tool
B face of the cutting tool at a short distance from the cutting edge only
C cutting edge only
D front face only

Next steps