Which command will delete the contents of NVRAM on a router?

A <code class="args"><em>delete NVRAM</em></code>
B <code class="args"><em>delete startup-config</em></code>
C <code class="args"><em>erase NVRAM</em></code>
D <code class="args"><em>erase start</em></code>

Correct Answer: <code class="args"><em>erase start</em></code>

The erase startup-config command erases the contents of NVRAM and will put you in setup mode if the router is restarted.
Bissoy MCQ
#Networking #IOS And Security Device Manager

Related Questions

If you delete the contents of NVRAM and reboot the router, what mode will you be in?
A Privileged mode
B Global mode
C Setup mode
D NVRAM loaded mode
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
If you wanted to delete the configuration stored in NVRAM, what would you type?
A erase startup
B erase nvram
C delete nvram
D erase running
What command do you type to save the configuration stored in RAM to NVRAM?
A Router (config) #copy current to starting
B Router #copy starting to running
C Router (config) #copy running - config startup - config
D Router#copy run start
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
Which router command allows you to view the entire contents of all access lists?
A show all access-lists
B show access-lists
C show ip interface
D show interface
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
Which command is used to delete the directory and all its contents in one step?
A DEL *.*
B RD
C DELTREE
D CD
E None of the above

Next steps