Bissoy.com
Doctors Medicines MCQs Q&A

An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed

An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed Correct Answer 795mV

Related Questions

An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed
For an instrumentation amplifier, the following parameters are given (a) High input resistance and low power consumption (b) Low input resistance and low power consumption (c) High CMRR and high slew rate (d) Low CMRR and high slew rate Which of the given parameters are a major requirement for an instrumentation amplifier?
Determine the slew rate of the amplifier having full power bandwidth f0 and the rated output voltage as V0. Given that the input signal is of sinusoidal nature.
A government official said, “Currently, the traffic signals installed along the roads have a fixed signal timer but with the Japanese technology, signals will automatically change according to the number of vehicles along the road.” Which of the following could be the reason for the statement? I: The installation of smart signals will reduce the waiting time at signals and junctions. II: The installation of smart signals will solve the traffic woes in the city. III: The technology will be an integrated traffic management center that will ease congestion in the city.
Consider the following statements. It converts the positive half cycle of the sinusoidal wave of the input to the pulsating DC output signal. It converts the positive half as well as negative half cycle of the sinusoidal wave of the input to pulsating DC output signal. Which of the following statements is CORRECT about half-wave rectifier?
In designing with op amps one has to check the limitations on the voltage and frequency ranges of operation of the closed-loop amplifier, imposed by the op-amp finite bandwidth (ft), slew rate (SR), and output saturation (Vo max). Consider the use of an op amp with ftt = 2 MHz, SR = 1 V/µs, and V0 max = 10 V in the design of a non-inverting amplifier with a nominal gain of 10. Assume a sine-wave input with peak amplitude Vi. If Vi = 0.5 V, what is the maximum frequency before the output distorts?
In designing with op amps one has to check the limitations on the voltage and frequency ranges of operation of the closed-loop amplifier, imposed by the op-amp finite bandwidth (ft), slew rate (SR), and output saturation (Vo max). Consider the use of an op amp with ftt = 2 MHz, SR = 1 V/µs, and V0 max = 10 V in the design of a non-inverting amplifier with a nominal gain of 10. Assume a sine-wave input with peak amplitude Vi. If f = 20 kHz, what is the maximum value of Vi before the output distorts?
An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ & Output resistance of 2.5 kΩ.The input resistance of the current shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is
Given that for an op-amp the gain is 103, the slew rate is 1.5V/μsec. Input is 5×10-3sinωt, calculate maximum frequency to prevent distortion.
A 741-Type OP-amp has a gain-bandwith product of 1MHz. A non-inverting amplifier using this opamp & having a voltage gain of 20db will exhibit -3db bandwidth of