Bissoy.com
Doctors Medicines MCQs Q&A

Given that for an op-amp the gain is 103, the slew rate is 1.5V/μsec. Input is 5×10-3sinωt, calculate maximum frequency to prevent distortion.

Given that for an op-amp the gain is 103, the slew rate is 1.5V/μsec. Input is 5×10-3sinωt, calculate maximum frequency to prevent distortion. Correct Answer 47.7 kHz

dVOUT(max)/dT =< Slew rate A.Vmω =< 1.5 V/μsec 103.5.10-3.ω = < 1.5×106 ω=<0.3×106 Frequency f = 0.0477×106Hz.

Related Questions

An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed
An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed
For an instrumentation amplifier, the following parameters are given (a) High input resistance and low power consumption (b) Low input resistance and low power consumption (c) High CMRR and high slew rate (d) Low CMRR and high slew rate Which of the given parameters are a major requirement for an instrumentation amplifier?
In designing with op amps one has to check the limitations on the voltage and frequency ranges of operation of the closed-loop amplifier, imposed by the op-amp finite bandwidth (ft), slew rate (SR), and output saturation (Vo max). Consider the use of an op amp with ftt = 2 MHz, SR = 1 V/µs, and V0 max = 10 V in the design of a non-inverting amplifier with a nominal gain of 10. Assume a sine-wave input with peak amplitude Vi. If Vi = 0.5 V, what is the maximum frequency before the output distorts?
An opamp has a slew rate of 5 V/μS. The largest sine wave output voltage possible at a frequency of 1MHz is
The given table shows the number of employees appointed by different organizations in the given years.   Year Organizations P Q R S T U 2007 92 102 84 100 95 98 2008 104 107 94 99 96 105 2009 96 119 93 102 98 103 2010 101 100 86 88 97 107 2011 85 117 84 103 102 99 2012 88 97 89 100 103 102 What is the respective ratio between the total employees appointed by the organization U in the year 2010 and 2012, and the total employees appointed by the organization P in the same years?
The given table shows the number of employees appointed by different organizations in the given years. Year Organizations P Q R S T U 2007 92 102 84 100 95 98 2008 104 107 94 99 96 105 2009 96 119 93 102 98 103 2010 101 100 86 88 97 107 2011 85 117 84 103 102 99 2012 88 97 89 100 103 102   In the year 2008, the number of employees appointed by the organization R is how much percentage more from the previous year? (Around the nearest integer)
Calculate the maximum input frequency at which the output will be distorted from the given specifications Vo = 30 Vpp ; Slew rate = 0.6v/µs.
In designing with op amps one has to check the limitations on the voltage and frequency ranges of operation of the closed-loop amplifier, imposed by the op-amp finite bandwidth (ft), slew rate (SR), and output saturation (Vo max). Consider the use of an op amp with ftt = 2 MHz, SR = 1 V/µs, and V0 max = 10 V in the design of a non-inverting amplifier with a nominal gain of 10. Assume a sine-wave input with peak amplitude Vi. If f = 20 kHz, what is the maximum value of Vi before the output distorts?
What is the total harmonic distortion if the amplitude of first harmonic distortion is 20dB and second harmonic distortion 25dB?