IDE is an

A Individual Application Software
B Workgroup Application Software
C Organizational Application Software
D Inter Organizational Application Software

Correct Answer: Workgroup Application Software

6 জনে 8 ঘন্টা কাজ করে পায় 8400 টাকা ∴ 6 " 1 '' '' '' '' 84008 ∴ 1 '' 1 '' '' '' '' 84008×6 '' ∴ 1 " 6 " " " " 8400×68×6 " ∴ 9 " 6 " " " " 8400×6×98×6 " = 9450 টাকা।
Bissoy MCQ
#সাধারণ জ্ঞান #Dhaka Bank Ltd #Dhaka Bank Ltd - Trainee Officer - 22.09.2017

Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.
A cable sequence
B jumpers on the hard drive
C drivers that need to be loaded
D hard drive manufacturer web site information
E None of the above
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
A C
B D
C E
D F
E None of the above
Which of the following is not an IDE
A BlueGriffon 1.5.2
B Aptana studio 3
C TextEdit(Mac)
D Dreamweaver
IDE stands for
A Internet Development Environment
B Integrated Development Environment
C Intelligent Development Environment
D None of the mentioned
IDE cables have how many pins?
A 25
B 50
C 100
D 40
E 65
Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.
A bad data cable
B incorrect jumper setting on drive
C loose molex connector
D virus
E tfad system board
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format

Next steps