Bissoy.com
Doctors Medicines MCQs Q&A

In electric arc wire spray process, preheating of metal before welding is mainly done to prevent surface cracking.

In electric arc wire spray process, preheating of metal before welding is mainly done to prevent surface cracking. Correct Answer True

In salvaging of the casting metal, the weld-ability may depend on special techniques. For example, preheating before welding is mainly done to prevent cracking due to thermal stresses and to reduce residual stresses, distortion and hardness of the casting metal. This makes electric arc wire spray process easy and reliable.

Related Questions

Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
In a metal arc welding process, metal transfer across the arc may take place by a method of material transfer where the metal transfers across the arc is in larger drops. This is at the rate of 100 drops/sec or less, what is this known as
In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position.
In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as
When the main switch of the house is put off it disconnects the: (A) Live wire only (B) Live wire and the earth wire (C) Live wire and the neutral wire (D) Earth wire and the neutral wire
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
A telephone switchboard 100 pair cable can be made up with either enameled wire or tinned wire. There will be 400 soldered connections. The cost of soldering a connection on the enameled wire will be P 1.65 on the tinned wire, it will be P 1.15. A 100- pair cable made up with enameled wire cost P 0.55 per linear foot and those made up of tinned wire cost P 0.75 per linear foot. Determine the length of cable run in feet so that the cost of each installation would be the same.
In electric arc wire spray process, the atomizing air pressure is the only significant variable for controlling the surface layers.
What is the differentiating factor between flux core arc welding and gas-shielded metal arc welding processes?
What is the effective throat thickness dimension of 10mm fillet weld made by shielded metal arc welding and submerged arc welding?