Bissoy.com
Doctors Medicines MCQs Q&A

What is the effective throat thickness dimension of 10mm fillet weld made by shielded metal arc welding and submerged arc welding?

What is the effective throat thickness dimension of 10mm fillet weld made by shielded metal arc welding and submerged arc welding? Correct Answer 7mm, 8.6mm

a) Using shielded metal arc welding process, effective throat thickness = 0.7a = 0.7×10 = 7mm b) Using submerged arc welding (we get better penetration than shielded metal arc welding): a = 10+2.4 = 12.4mm effective throat thickness = 0.7a = 0.7×12.4 = 8.6mm.

Related Questions

In the consumable electrode shielded metal arc welding process, which of the following observations are correct?
P. The, weld composition does not depend upon the basicity of the slag.
Q. Basic flux is used to achieve low hydrogen content-and low inclusion content in the weld metal.
R. Reverse polarity of the direct current power source is used to weld thin sheets.
S. Coated electrodes are classified by tensile strength of the weld metal deposit.
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is
Parallel fillet weld and transverse fillet weld both have the plane in which maximum shear stress occurs at 45’ to the leg dimension.
Which of the following statements are correct in respect of welded connections? 1) Strength of Butt weld is equal to the strength of components joined. 2) Fillet welds carry the loads computed based on the tensile strength characteristics of fusion material. 3. for effective transmission of load by fillet weld, the fusion faces shall subtend an angle between 60° and 120° 
Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)
With reference to the following figure, a plate, 75mm wide and 10mm thick, is joined with another plate as shown. The permissible tensile and shear stress in the welds are 50/mm² and 40N/mm². Determine the required length of each parallel fillet weld if length of transverse weld is 40mm.
What is the differentiating factor between flux core arc welding and gas-shielded metal arc welding processes?
Referring to the below figure, determine the required length of the weld joining two steel plates which are 10mm wide and 10mm thick. The permissible shear stress in the weld is 80N/mm².