Bissoy.com
Doctors Medicines MCQs Q&A

In a metal arc welding process, metal transfer across the arc may take place by a method of material transfer where the metal transfers across the arc is in larger drops. This is at the rate of 100 drops/sec or less, what is this known as

In a metal arc welding process, metal transfer across the arc may take place by a method of material transfer where the metal transfers across the arc is in larger drops. This is at the rate of 100 drops/sec or less, what is this known as Correct Answer Dip transfer

In short-circuiting or 'dip' transfer, the molten metal forming on the tip of the wire is transferred by the wire dipping into the weld pool.In a metal arc welding process, metal transfer across the arc may take place by a method of material transfer where the metal transfers across the arc is in larger drops. This is at the rate of 100 drops/sec or less, what is this known as Dip Transfer

Related Questions

Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
Ayesha put two drops of oil on the lid of her tiffin box. Next to that, she put two drops of water and two drops of sugar solution. She tilted the lid. She saw some drops slid down quickly, while some were left behind. Which drops slid down her tiffin box the fastest?
In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as
Following are general statements about water drops. (a) Surface tension is responsible for the spherical shape of the water drops. (b) Even in the absence of gravitation, water drops have a spherical shape. (c) Formation of water drops occurs, if the mass of the water is stretched. Which of the above statement/statements is/are correct?
In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position.
If the total efficiency is 0.35 in arc welding. Then what is the welding speed in mm/sec if the cross-sectional area is 5mm2, welding power is 2 kW and the heat required in melting the metal is 100 J/mm3.
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
An Investigator interviewed 100 students to determine the performance of three drinks milk, coffee and tea. The investigator reported that 10 students take all three drinks, 20 students take milk and coffee, 30 students take coffee and tea; 25 students take milk and tea; 12 students take milk only. 5 students take coffee only and 8 student take tea only. Then the number of students who did not take any of the three drinks is λ. The value of \(\frac{\lambda }{4}\) is equal to
Study information given and select valid conclusion/s from the given statements based on it. In a joint family the number of members who take only coffee is equal to the half the number of members who take tea and the number of persons who take only tea is equal to the half the number of persons who take coffee. Statements: a. The total number of persons who take either coffee or tea or both is thrice the number of persons who take only coffee or only tea. b. The total number of persons who take only coffee and those who take only tea is twice the number of persons who take both coffee and tea.
From the given table, what is the percentage of students scoring 40 or more, but less than 70. Scores Less than 20 Less than 30 Less than 40 Less than 50 Less than 60 Less than 70 Less than 80 No. of Students 12 19 22 31 38 46 50