Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
In a motor of 120 machine parts, 5% parts were defective. In another motorof 80 machine parts, 10% parts were defective. For the two motors considered together,the percentage of defective machine parts were
The pie chart given below shows the amount spent by a boy on the purchase of six different items. The total amount spent on all these six items is Rs. 54000. The amount spent on a specific item is represented as a degree with reference to the total amount spent on all these six items. Which of the following statement(s) is/are correct? I. The amount spent on article A is Rs.900 less than the amount spent on article B. II. The amount spent on article C is Rs 2400 more than the amount spent on article D. III. The ratio of the amount spent on article B to the amount spent on article E is 4 : 1.
Water Jet Machining (WJM) and Abrasive Jet Micromachining (AJMM or AWJM) can be achieved using how many different approaches?
In Abrasive jet machining, what may be the size of the abrasive grains used?
What is the value of abrasive grain flow rate in Abrasive jet machining?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?