Bissoy.com
Doctors Medicines MCQs Q&A

What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?

What is the grain size of abrasive particles, which are often used for Abrasive water jet machining? Correct Answer 10 – 150 µm

Grain size of the abrasive particles range between 10 – 150 µm in Abrasive water jet machining.

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
The largest size of immobilised segment of dislocation in a Frank Read (FR) source contained in a polycrystalline material is of the order of grain size. In a metal of 10 μm grain size, the shear stress required to operate such a FR source is 100 MPa. If the grain size in the same metal is reduced to 10 μm, the shear stress required to operate such FR source would be . . . . . . . . MPa.
What is the value of abrasive grain flow rate in Abrasive jet machining?
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
Kamala has three cylindrical containers, each with radius 20 cm that she wants to fill with grain. If her bag of grain contains 100 kg of grain, and she fills all three containers to a height of 70 cm, how much grain will be left in the bag, if 1 kg grain occupies 3000 cm3 space? (Use π = \(\frac{{22}}{7}\))
In Abrasive jet machining, what may be the size of the abrasive grains used?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
In Abrasive water jet machining, how are the abrasives fed into the water jet stream?
In order to double its yield strength, the grain size of a steel of ASTM grain size number 2 should be changed to ASTM grain size number (neglect friction stress)