Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
State whether the following statement is true or false. “In Abrasive jet machining, commercial grades powders can be used for machining.”
In machining system of AJM, which is the medium of carrying the abrasive grains for machining?
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.
What is the value of abrasive grain flow rate in Abrasive jet machining?
Abrasive flow value in Abrasive water jet machining will range between which of the following values?