Bissoy.com
Doctors Medicines MCQs Q&A

State whether the following statement is true or false. “In Abrasive jet machining, commercial grades powders can be used for machining.”

State whether the following statement is true or false. “In Abrasive jet machining, commercial grades powders can be used for machining.” Correct Answer False

For AJM, commercial grade powders are not used because their sizes are not classified widely.

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
State whether the following statement is true or false about Abrasive water jet machining. “A material, whose material removal rate is higher, produces larger surface roughness.”
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
In Abrasive jet machining, what may be the size of the abrasive grains used?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?
Two processes X and Y need to access a critical section. Consider the following synchronization construct used by both the processes Process ? /* other code for process ? */ while(true) { varP = true; while(varQ == true) { /* Critical Section */ varP = false; } } /* other code for process ?? */   Process ? /* other code for process ? */ while(true) { varQ = true; while(varP == true) { /* Critical Section */ varQ = false; } } /* other code for process ? */   Here, varP and varQ are shared variables and both are initialized to false. Which one of the following statements is true?
Performance of 1800 students in grades has been shown in the following pie chart. In which two grades taken together is the number of students 54 less than the number of students in grades B and E taken together?
Abrasive flow value in Abrasive water jet machining will range between which of the following values?
A statement is given below in the question followed by three courses of actions numbered I, II and III. On the basis of the information given, you have to assume everything in the statement to be true, and then decide which of the following suggested courses of actions logically follow(s) for pursuing. Statement: Jet Airways has defaulted on salary payments again. The cash-strapped airline on Wednesday sought over 10 more days from its employees to pay balance 25 per cent of their salaries for August. Jet Airways had paid 50 per cent of August salaries to its employees on September 11 and the rest was to be paid on Wednesday. But it could pay only half of the balance amount.  Courses of action: I. The cash-strapped airline, which is struggling to meet its cost of operations, had earlier attempted to cut salaries of its employees, but the move was met with stiff resistance that forced it to defer the plan.  II. Jet Airways will today remit half of the second installment of pending emoluments of its pilots, AMEs and senior management for August 2018. III. While the management regrets the attendant inconvenience, it also appreciates the continued support and understanding of its employees.