Bissoy.com
Doctors Medicines MCQs Q&A

Due to slip of the belt, the velocity ratio of the belt drive

Due to slip of the belt, the velocity ratio of the belt drive Correct Answer decreases

The result of the belt slipping is to reduce the velocity ratio of the system. As the slipping of the belt is a common phenomenon, thus the belt should never be used where a definite velocity ratio is of importance.

Related Questions

Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
Due to slip of belt, the velocity ratio of the belt drive increases.
The ratio of belt tensions $$\frac{{{{\text{p}}_1}}}{{{{\text{p}}_2}}}$$ considering centrifugal force in flat belt is given by where,
m = mass of belt per meter (kg/m)
v = belt velocity (m/s)
f = coefficient of friction
$$\alpha $$ = angle of wrap (radians)
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
For a flat open-belt drive, the belt speed is 880 m/min and the power transmitted is 22.5 kW. What is the difference between the tight side and slack side tensions of the belt drive?
Which one of the following four addresses is NOT EXACTLY same as the one given below? Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (i) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (ii) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iii) Cabrematta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iv) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia
Which one of the following four addresses is NOT EXACTLY same as the one given below?  Kedrick Shaw 72 Glenwood Drive, Thornton, NSW 2322, Australia (i)  Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (ii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iv) Kedrick Shaw  72 Glemwood Drive,  Thornton, NSW 2322, Australia
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))