Bissoy.com
Doctors Medicines MCQs Q&A

In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be

In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be Correct Answer 0.96

Related Questions

The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. Calculate the tension in the rope of pulley C.
Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is?
If the angle of wrap on smaller pulley of diameter 250 mm is 1200 and diameter of larger pulley is twice the diameter of smaller pulley, then the centre distance between the pulleys for an open belt drive is
Statement (I): When a flat-faced follower is used, it would be preferable to provide an offset in the plane perpendicular to the plane of rotation of the cam. Statement (II): Because of the offset, the follower is made to rotate continuously about its axis which in turn avoids jamming of the follower in its guide while moving up or down, reduces the wear of the follower flat surface and distributes the wear uniformly.
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. If allowable shear stress in the shaft is 70N/mm² and torsional and bending moments are M=1185000N-mm and m=330000N-mm, find the diameter of the shaft.
The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm. Calculate the torque supplied to the shaft.
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
For same pulley diameters, center distance, belt speed and belt and pulley materials,
Six flats A, B, C, D, E and F are located in two rows of three flats each. The flats in both the rows face each other. Flat D is diagonally opposite to flat C. Flat E is opposite to flat F, which is north facing. Flat C is 2nd to the left of A and both of flats are south facing. Which of the following flats is facing flat B?