Bissoy.com
Doctors Medicines MCQs Q&A

Mixing ratio in abrasive jet machining is defined as a ratio of

Mixing ratio in abrasive jet machining is defined as a ratio of Correct Answer Mass flow rate of abrasive to mass flow rate of gas

Mixing ratio in abrasive jet machining is defined as a ratio of mass flow rate of abrasive to mass flow rate of gas.

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
Product X is produced by mixing chemical A and chemical B in the ratio of 5 : 4. Chemical A is prepared by mixing two raw materials, P and Q, in the ratio of 1 : 3. Chemical B is prepared by mixing raw materials, Q and R, in the ratio of 2 : 1. Then the final mixture is prepared by mixing 8640 units of product X with water. If the concentration of the raw material Q in the final mixture is 50%, how much water had been added to product X?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
In Abrasive jet machining, what may be the size of the abrasive grains used?
What is the value of abrasive grain flow rate in Abrasive jet machining?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?
Abrasive flow value in Abrasive water jet machining will range between which of the following values?
Water Jet Machining (WJM) and Abrasive Jet Micromachining (AJMM or AWJM) can be achieved using how many different approaches?