Bissoy.com
Doctors Medicines MCQs Q&A

Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of shear force in Kg?

Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of shear force in Kg? Correct Answer 215.71

tan (shear angle)= (r*cos(rake angle))/ (1-r*sin(rake angle)). Shear force=Cutting force*cos(shear angle)-feed force*sin (shear angle).

Related Questions

Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of the shear angle in degrees?
Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of friction angle?
Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of normal force in Kg?
Feed force of 210Kg and cutting force of 310Kg are applied using a tool of rake angle 10 degrees. If chip thickness ratio is 0.36, what will be the value of a coefficient of friction?
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90°, the shear angle in degree is
In an orthogonal machining operation : Uncut thickness = 0.5 mm Cutting speed = 20 m/min Rake angel = 150 Width of cut = 5 mm Chip thickness = 0.7 mm Thrust force = 200 N Cutting force = 1200 N The values of shear angle and shear strain, respectively, are
In a single point turning tool, the side rake angle and orthogonal rake angle are equal. ϕ is the principal cutting edge angle and its range is 000. The chip flows in the orthogonal plane. The value of ϕ is closest to
In the metal cutting operation, what will be the shear angle when a cutting tool has positive rake angle α = 20°. The friction angle is 40°. (Use Merchant's shear angle theory)
A single-point cutting tool with 120C rake angle is used to machine a steel work-piece. The depth of cut, i.e., uncut thickness is 0.81 mm. The chip thickness under orthogonal machining condition is 1.8 mm. The shear angle is approximately