Bissoy.com
Doctors Medicines MCQs Q&A

The galvanometer, which needs a frequency response of only 3 MHz, is positioned by a servo motor through a silent step-down belt drive.

The galvanometer, which needs a frequency response of only 3 MHz, is positioned by a servo motor through a silent step-down belt drive. Correct Answer False

The galvanometer, which needs a frequency response of only 3 Hz, is positioned by a servo motor through a silent step-down belt drive. Recording sensitivity is 20 bpm/cm giving a basic resolution of 1 bpm for seeing small changes in the heart rate.

Related Questions

The Department of Telecommunications has issued a notice inviting applications for auction of Spectrum in 700 megahertz, 800 MHz, 900 MHz, 1800 MHz, 2100 MHz, 2300 MHz and 2500 MHz bands. The validity of auctioned Spectrum shall be how many years?
Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
A GSM cellular telephone standard requires a minimum of 9 dB rejection of interfering signal levels of -23 dBm at 3 MHz from the carrier, -33 dBm at 1.6 MHz from the carrier, and -43 dBm at 0.6 MHz from the carrier, for a carrier level of -99 dBm. Determine the required local oscillator phase noise at 3 MHz carrier frequency offset.
Maslow's need-hierarchy theory of motivation has classified the human needs into five categories as follows. Arrange the following needs in ascending order given by Maslow
1. Safety needs
2. Esteem needs
3. Social needs
4. Physiological needs
5. Self-actualisation needs
What is the sequence of domtion of these needs?
In the hierarchical theory of Maslow, the needs are classified as 1. physiological needs 2. self - actualization needs 3. needs of belong 4. esteem needs 5. safety needs Which of the following is the correct sequence of the hierarchy of these needs from bottom to the top according to Maslow?
Which of the following is the correct order of human needs as formulated in Maslow's hierarchy of needs? a) Safety needs b) Love and belonging needs c) Physiological needs d) Self-actualisation needs e) Esteem needs Choose the most appropriate answer from the options given below:
The current passing through a galvanometer is 30 mA, resistance of the galvanometer is 50 Ω and a shunt is 1 Ω is connected to the galvanometer. What is the maximum current that can be measured by this ammeter?
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
For a flat open-belt drive, the belt speed is 880 m/min and the power transmitted is 22.5 kW. What is the difference between the tight side and slack side tensions of the belt drive?
In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be