Bissoy.com
Doctors Medicines MCQs Q&A

We need the biasing of differential relay biased to avoid mal operation when used for transformer protection due to ____________

We need the biasing of differential relay biased to avoid mal operation when used for transformer protection due to ____________ Correct Answer mismatch of CT

It is not practical to use CT of exact type, so the mal operation may occur due to mismatch of current transformers.

Related Questions

If a transformer is provided with differentially connected relay. To prevent the mal operation of the relay, the relay relay operating coil is biased with ______
If a transformer is provided with differentially connected relay. To prevent the mal operation of the relay, the relay restraining coil is biased with ______________
Statement: Syrian President Bashar al-Assad has revealed during an interview that a direct clash between the US and Russia in Syria was narrowly avoided "by the wisdom of the Russian leadership".  Which of the following objection(s) might be a probable reason(s) for such a revelation by Syrian President Bashar al-Assad? I. Adding that Syria needs Russian support, Assad said, "At the same time we need to avoid the American foolishness in order to be able to stabilise our country". II. Adding that Syria needs American support, Assad said, "At the same time we need to avoid the American foolishness in order to be able to stabilise our country". III. Adding that Syria needs Russian support, Assad said, "At the same time we need to avoid the Russian foolishness in order to be able to stabilise our country". IV. Adding that Syria needs American support, Assad said, "At the same time we need to avoid the Russian foolishness in order to be able to stabilise our country".
Consider the following statements with respect to a relay: 1. A relay is energized if NC contacts are opened. 2. The pickup current is the minimum relay coil current required to keep a relay energized. Which of the above statements is/are correct?
Buchholz relay is a protection relay used in oil immersed transformers. Under what conditions does Buchholz Relay will NOT operate?
Which relay is a gas operated relay used for the protection of oil immersed transformer against the types of internal faults?
There exist three terminals in a relay called C, NO, NC, in an application, it is desired that whenever the relay is active the load must be connected be supply, otherwise the load will be disconnected from supply. Which of the following connection type in relay will provide solution to the stated problem?
A solenoid type relay is what type of relay as far as the relay timing is concerned?
Which of the following is the correct match based on the application of diodes? (considering general trends) (a) Zener diode -- Reverse biased (b) Photodiode - Forward biased (c) Half wave Rectifier - Both Forward and reversed biased
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?