Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
It is required to match a 200Ω load to a 300Ω transmission line to reduce the SWR along the line to 1. What must be the characteristic impedance of the quarter-wave transformer used for this purpose, if it is connected directly to the load?
What is the PEP if the transmitter produces a peak to peak voltage of 178V across a 75Ω load?
What is the Standing wave ratio if a 75Ω antenna load is connected to a 50Ω transmission line?
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
In connection with inspection and testing of concrete structures as per IS 456:2000, while conducting load tests on flexural members, what is the load (L) and minimum duration of load application(T) on the structure? (Use notations as : DL : dead Load, IL : Imposed load)
If SWR=1.5 with a wavelength of 4 cm and the distance between load and first minima is 1.48cm, then the reflection coefficient is:
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?
What is the partial safety factor for dead load in combination of DL+LL+WL/EL for limit state of serviceability, where DL=Dead load, LL=imposed load , WL=wind load, EL=earthquake load ?
A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the power delivered to the load.