Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
Phosphoenolpyruvate (PEP) is converted to oxaloacetate by the enzyme PEP deaminase.
The ratio between transmitter chip clock rate and the difference between the transmitter chip clock and difference between transmitter and receiver chip clock rates is called ___________
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
A dynamometer type wattmeter with its voltage coil connected across the load side of the instrument reads 200 W. If the load voltage be 240 V, then what power is being taken by the load? The voltage coil branch has a resistance of 1,500 Ω
What is the average power of the transmitter if PEP = 500W?
A suspension string have 3 units. Voltage across topmost and lower most unit of string are 6.71 volts and 11 volts respectively. What is the voltage across middle string, if voltage across whole string is 25.76 volts?
If voltage across lowermost unit of a string is 34.8% of voltage across whole string and string efficiency is 57.46%. What is the voltage across whole string.
Specification of op-amp 741c is given below: A=200000; Ri=2MΩ; Ro=75Ω; Supply voltages= ±15v; output voltage swing =±13v; fo=5hz. Compute the value of output resistance, bandwidth and closed loop voltage gain for the circuit shown.
Find the difference between output current having a load of 100Ω and 120Ω for 7805 IC regulator. Consider the following specification: Voltage across the load = 5v; Voltage across the internal resistor= 350mv.