Bissoy.com
Doctors Medicines MCQs Q&A

Since multiple layers of semiconductor materials is used in high electron mobility transistors, this results in:

Since multiple layers of semiconductor materials is used in high electron mobility transistors, this results in: Correct Answer Thermal stress

The multiple layers in the high electron mobility transistor result in the thermal and mechanical stress in the layers. To avoid this, the layers usually have matched crystal lattice.

Related Questions

High electron mobility transistors can be constructed with the use of single semiconductor material like GaAs that have high electron mobility.
Which of the following are the properties of an electron? 1) Electron is a constituent of cathode ray 2) Electron is a negatively charged particle 3) The mass of the electron is equal to the mass of the proton 4) Electron is deflected by the electric field but not by magnetic field Select the correct answer using the code given below:
In a 3-input CMOS NAND gate, the substrate terminals of NMOS transistors are grounded (lowest potential available in the circuit) and the substrate terminals of PMOS transistors are connected to VDD (maximum positive potential available in the circuit). Which of the following transistors may suffer in this circuit from the body bias effect?
Find the velocity of an electron when its kinetic energy is equal to one electron volt (in 105m/s). Given charge of an electron e = 1.6 x 10-19 and mass of an electron m = 9.1 x 10-31.
Assertion (A): A high electron mobility transistor is based upon modulation-doped (GaAs - AlGaAs) single heterojunction structure. Reason (R): HEMT shows a very high noise figure and very low gain at very high microwave frequencies up to 70 GHz.
In a CE-JFET, the ratio of electron mobility to hole mobility is equal to
A particular intrinsic semiconductor has a resistivity of 50 (ohm-cm) at T = 300 K and 5 (ohm-cm) at T = 330 K. If change in mobility with temperature is neglected, the bandgap energy of the semiconductor is
Which of the following components is used to create an N-type semiconductor? a. Trivalent impurity b. Pentavalent impurity c. Intrinsic semiconductor d. Extrinsic semiconductor
Consider the following statements: 1. Both ferromagnetic and ferrimagnetic materials have domain structures; each domain has randomly oriented magnetic moments when no external field is applied. 2. Both ferromagnetic and ferrimagnetic materials make those domains that have a favourable orientation to the applied field grow in size. 3. The net magnetic moment in ferromagnetic materials is higher than that in ferrimagnetic materials. 4. The net magnetic moment in ferrimagnetic materials is higher than that in ferromagnetic material. Which of the above statements are correct?
Six volts is applied across a 2 cm long semiconductor bar. The average drift velocity is 104 cms. The electron mobility is