Bissoy.com
Doctors Medicines MCQs Q&A

For a D Flip-Flop with a Clock Enable input, what happens to the output (Q) if the Clock Enable input is inactive?

For a D Flip-Flop with a Clock Enable input, what happens to the output (Q) if the Clock Enable input is inactive? Correct Answer Output remains unchanged

In a D Flip-Flop with a Clock Enable input, the output of the D Flip-Flop does not change if Clock Enable input is inactive. For a D Flip-Flop with a Clock Enable input, the output of the Flip-Flop cannot change unless the clock enable input is active.

Related Questions

Consider the following statements: 1. Race-around condition occurs in a JK flipflop when the inputs are 1, 1 2. A flip-flop is used to store one bit of information 3. A transparent latch consists of D-type flipflops 4. Master-slave configuration is used in a flipflop to store two bits of information Which of the above statements are correct?
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
There are 3 clocks located at California, Berlin and Beijing respectively. If the hour hand of the clock at California is rotated by 270 degrees, then it will show same time as clock in Berlin. If the hour hand of clock in Berlin is rotated by 180 degrees, then it will show same time as clock in Beijing. If time at clock at Beijing is 8 : 30 PM what time is clock at California showing?
A clock strikes once at 1 o'clock, twice at 2 o'clock and thrice at 3 o'clock, and so on. If it takes 12 seconds to strike at 5 o'clock, what is the time taken by it to strike at 10 o'clock?
In the question one statement is given, followed by two conclusions, I and II. You have to consider the statement to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statement. Statement: A function is a relation between a set of input elements and a set of possible output elements where each input is related to exactly one output. Conclusion I: Every input element is related to every output element. Conclusion II: Every input element is related to one element of the output.
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
A clock strikes once at 1 O'clock, twice at 2 O'clock twice at 2 O'clock, thrice at 3 O'clock and so on. How many times will it strike in 24 hours
Three friends converted the time of 24 hours clock in that of 12 hour clock as follows: Name of the children Time in 24 hour clock Time in 12 hour clock Cheeku 23:45 11:45 pm Bittu  16:30 04:30 am Pinki 19:28 07:28 pm Who has shown incorrect time in 12 hour clock?
A clock rings once in 1 O' clock, twice in 2 O' clock and thrice in 3 O' clock and so on, then how much time the clock ring in a day (24 hours)?
Assume that 1. the hour and minute hands of a clock move without jerking. 2. the clock shows a time between 8 o'clock and 9 o'clock 3. the two hands of the clock are one above the other. After how many minute (nearest integer) will the two hands be again lying one above the other?