If an isometric drawing is made use of isometric scale then the drawings are called ___________

If an isometric projection is drawn with true measurements but not with isometric scale then the drawings are called ____________

A

Isometric projection

B

Isometric view

C

Isometric perception

D

Orthographic view

In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: All icons are drawings Statement II: No portraits are icons Conclusion I: Some drawings are portraits Conclusion II: All portraits are drawings

A

Only conclusion I follows

B

Only conclusion II follows

C

Both conclusions I and II follow

D

Neither conclusion I nor conclusion II follows

What is the difference between isometric projection and isometric drawings?

A

Isometric drawings are drawn using true lengths whereas isometric projections are foreshortened by 18% of true length

B

Isometric projections are drawn using true lengths whereas isometric drawings are foreshortened by 18% of true length

C

Isometric drawings are drawn using true lengths whereas isometric projections are foreshortened by 12% of true length

D

Isometric projections are drawn using true lengths whereas isometric drawings are foreshortened by 12% of true length

Lines of an isometric drawing that are not parallel to the isometric axes are called this:

A

Trimetric lines

B

Non-isometric lines

C

Multiview lines

D

Dimetric lines

In engineering drawings, the three-view multi-view drawing is standard. What are the collections of three-view drawings?

A

The top, front, and the left-side views

B

The front, bottom and the right-side views

C

The bottom, rare and the top views

D

The top, front and the right side views

What is the APGAR scale? A. Scale to measure the height of mountains B. Time Measuring Scale C. Scale to determine the physical condition of a newborn D. Longevity scale

A

C

B

A

C

B

D

Arrange in the correct sequence from the lowest to the highest scale of measurement.
1. Interval scale
2. Ordinal scale
3. Ratio scale
4. Nominal scale

A

4, 2, 1, 3

B

1, 2, 3, 4

C

2, 1, 3, 4

D

2, 4, 3, 1

A machine part is drawn two times with different scales. The ratio of 1st drawing’s R.F. to 2nd drawing R.F. with respect to the actual object is found to be 2. The length of the second drawing is 10 mm. Find the 1st drawing length.

A

5 mm

B

200 mm

C

5 cm

D

2 cm

Front view of triangle is given and isometric view is to be drawn which of the following is correct procedure in drawing isometric view.

A

turning the triangle such that base is making 30 degrees with horizontal

B

by increasing or decreasing angles at required proportions

C

drawing parallel to isometric axes

D

drawing rectangle with base and height of triangle and the drawing rectangle parallel to isometric axes and pointing triangle in it

Front view of circle is given and isometric view is to be drawn which of the following is correct procedure in drawing isometric view?

A

turning the circle such that line on diameter is making 30 degrees with horizontal

B

by increasing or decreasing angles between two perpendicular line on diameter at required proportions

C

drawing line in diameter parallel to isometric axes

D

enclosing circle in a square and aligning square to isometric axes and pointing four points on circle touching the square and joining by smooth curve.

If an isometric drawing is made use of isometric scale then the drawings are called ___________

Related Questions