Bissoy.com
Doctors Medicines MCQs Q&A

A sliding member AB has attached to a rocker BC, this BC is attached to crank CD. D is fixed end and as crank is rotating about D the slider slides parallel to it. What is the locus of C?

A sliding member AB has attached to a rocker BC, this BC is attached to crank CD. D is fixed end and as crank is rotating about D the slider slides parallel to it. What is the locus of C? Correct Answer Circle

The whole mechanism given here is a slider crank mechanism. The asked point C which is at end of crank always rotates around the D and the member length will not change so the curve traced by that point is circle.

Related Questions

A sliding member AB has attached to a rocker BC, this BC is attached to crank CD. D is fixed end and as crank is rotating about D the slider slides parallel to it. What is the locus of point P on any point on the rocker?
For realizing a binary half-subtractor having two inputs A and B, the current set of logical expression for the outputs D (A minus B) and X (borrow) are 1. The difference output D = A̅B + AB̅ 2. The borrow output B = AB̅ Which of the above statements is/are correct? 
Consider the following statements: In a slider-crank mechanism, the slider is at its dead centre position when the (i) slider velocity is zero (ii) slider velocity is maximum (iii) slider acceleration is zero (iv) slider acceleration is maximum Which of the above statements are correct?
In a slider crank mechanism, the length of the crank and connecting rod are 150 mm and 600 mm respectively. The crank position is 60° from inner dead centre. The crank shaft speed is 400 r.p.m. (clockwise). Velocity of the slider is ________
In a slider-crank mechanism, the crank is rotating with an angular velocity of 20 rad/s in counterclockwise direction. At the instant when the crank is perpendicular to the direction of the piston movement, velocity of the piston is 2 m/s. Radius of the crank is
The velocity of a slider with reference to a fixed point about which a bar is rotating and slider sliding on the bar will be
Below are given statements. You have to take the given statements to be true even if they appear to be at variance with commonly known facts, and then decide which of conclusions logically follows from the given statements. For each question, mark out an appropriate answer choice that you think is correct. Statements: Some doors are slides. All slides are rooms. Some rooms are works. No work is code. Conclusions: 1) Some slides are works. 2) Some rooms are not code. 3) 100% rooms are slides. 4) Some doors are works.
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘a’ in mm.
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘c’ in mm.
If the crank rotation angle varies from 45 degrees to 135 degrees, Using three precision points with chebyshev’s spacing, synthesize a slider crank mechanism where where displacement of slider is square of the crank rotation. From the above information calculate ‘b’ in mm.