Bissoy.com
Doctors Medicines MCQs Q&A

A 12 MHz clock frequency is applied to a cascaded counter containing a modulus-5 counter, a modulus-8 counter, and a modulus-10 counter. The lowest output frequency possible is ________

A 12 MHz clock frequency is applied to a cascaded counter containing a modulus-5 counter, a modulus-8 counter, and a modulus-10 counter. The lowest output frequency possible is ________ Correct Answer 30 kHz

Cascaded counter containing a modulus-5 counter, a modulus-8 counter, and a modulus-10 counter. So, 5*8*10=400. Applied clock frequency = 12 MHz; hence, the lowest output frequency possible is 12MHz/400=30 kHz.

Related Questions

The Department of Telecommunications has issued a notice inviting applications for auction of Spectrum in 700 megahertz, 800 MHz, 900 MHz, 1800 MHz, 2100 MHz, 2300 MHz and 2500 MHz bands. The validity of auctioned Spectrum shall be how many years?
A GSM cellular telephone standard requires a minimum of 9 dB rejection of interfering signal levels of -23 dBm at 3 MHz from the carrier, -33 dBm at 1.6 MHz from the carrier, and -43 dBm at 0.6 MHz from the carrier, for a carrier level of -99 dBm. Determine the required local oscillator phase noise at 3 MHz carrier frequency offset.
A digital CMOS IC operating at 10 MHz clock frequency consumes 100 mW power; the same IC operating at 15 MHz clock frequency consumes 140mW power. What is the static power consumption of the IC?
A clock strikes once at 1 o'clock, twice at 2 o'clock and thrice at 3 o'clock, and so on. If it takes 12 seconds to strike at 5 o'clock, what is the time taken by it to strike at 10 o'clock?
There are 3 clocks located at California, Berlin and Beijing respectively. If the hour hand of the clock at California is rotated by 270 degrees, then it will show same time as clock in Berlin. If the hour hand of clock in Berlin is rotated by 180 degrees, then it will show same time as clock in Beijing. If time at clock at Beijing is 8 : 30 PM what time is clock at California showing?
The IS-54 digital cellular telephone system uses a receive frequency band of 869-894 MHz, with a first IF frequency range of 87 MHz, one possible range of local oscillator frequency is:
A 5-stage pipelined processor has Instruction Fetch (IF), Instruction Decode (ID), Operand Fetch (OF), Perform Operation (PO) and Write Operand (WO) stages. The IF, ID, OF and WO stages take 1 clock cycle each for any instruction. The PO stage takes 1 clock cycle for ADD and SUB instructions, 3 clock cycles for MUL instruction, and 6 clock cycles for DIV instruction respectively. Operand forwarding is used in the pipeline. What is the number of clock cycles needed to execute the following sequence of instructions? Instruction Meaning of instruction I0 : MUL R2, R0, R1 R2← R0 * R1 I1 : DIV R5, R3, R4 R5 ← R3 / R4 I2 : ADD R2, R5, R2 R2 ← R5 + R2 I3 : SUB R5, R2, R6 R5 ← R2 – R6
A clock rings once in 1 O' clock, twice in 2 O' clock and thrice in 3 O' clock and so on, then how much time the clock ring in a day (24 hours)?
Assume that 1. the hour and minute hands of a clock move without jerking. 2. the clock shows a time between 8 o'clock and 9 o'clock 3. the two hands of the clock are one above the other. After how many minute (nearest integer) will the two hands be again lying one above the other?
A clock strikes once at 1 O'clock, twice at 2 O'clock twice at 2 O'clock, thrice at 3 O'clock and so on. How many times will it strike in 24 hours