Bissoy.com
Doctors Medicines MCQs Q&A

In JK flip flop same input, i.e. at a particular time or during a clock pulse, the output will oscillate back and forth between 0 and 1. At the end of the clock pulse the value of output Q is uncertain. The situation is referred to as?

In JK flip flop same input, i.e. at a particular time or during a clock pulse, the output will oscillate back and forth between 0 and 1. At the end of the clock pulse the value of output Q is uncertain. The situation is referred to as? Correct Answer Race around condition

A race around condition is a flaw in an electronic system or process whereby the output and result of the process is unexpectedly dependent on the sequence or timing of other events.

Related Questions

Consider a combination of T and D flip-flops connected as shown below. The output of the D flip-flop is connected to the T flip-flop and the output of the T flip-flop is connected to the input of the D flip-flop. Initially, both Q0 and Q1 are set to 1 (before the 1st clock cycle). The outputs
In the T-type master-slave J-K flip-flop is shown along with the clock and input waveforms. The Qn output of flip-flop was zero initially. Identify the correct output waveform.
Electronics mcq question image
A cascaded arrangement of flip-flops, where the output of one flip flop drives the clock input of the following flip flop is known as
What gate is placed between clock input and the input of AND gate to convert a positive level triggered flip – flop to a negative level triggered flip – flop?
There are 3 clocks located at California, Berlin and Beijing respectively. If the hour hand of the clock at California is rotated by 270 degrees, then it will show same time as clock in Berlin. If the hour hand of clock in Berlin is rotated by 180 degrees, then it will show same time as clock in Beijing. If time at clock at Beijing is 8 : 30 PM what time is clock at California showing?
A Shift register in which the output of the last flip-flop is connected to the input of the first flip-flop
The ring counter is a serial shift register with feedback from the output of the last flip-flop to the input of the first flip-flop.
In a J-K flip-flop, if J=K the resulting flip-flop is referred to as _____________
For a 4 bit MOD-16 ripple counter using J-K flip-flop, the propagation delay of each flip flop is 50ns. What is the maximum clock frequency can be used?
For realisation of JK flip-flop from SR flip-flop, the input J and K will be given as ___________