Bissoy.com
Doctors Medicines MCQs Q&A

REPINS instruction is used to __________

REPINS instruction is used to __________ Correct Answer Transfer a block of data parallelly from Input device to the processor

Related Questions

A 5-stage pipelined processor has Instruction Fetch (IF), Instruction Decode (ID), Operand Fetch (OF), Perform Operation (PO) and Write Operand (WO) stages. The IF, ID, OF and WO stages take 1 clock cycle each for any instruction. The PO stage takes 1 clock cycle for ADD and SUB instructions, 3 clock cycles for MUL instruction, and 6 clock cycles for DIV instruction respectively. Operand forwarding is used in the pipeline. What is the number of clock cycles needed to execute the following sequence of instructions? Instruction Meaning of instruction I0 : MUL R2, R0, R1 R2← R0 * R1 I1 : DIV R5, R3, R4 R5 ← R3 / R4 I2 : ADD R2, R5, R2 R2 ← R5 + R2 I3 : SUB R5, R2, R6 R5 ← R2 – R6
Which of the following statements are correct? 1. Pseudo instruction is a machine instruction. 2. A pseudo instruction is an instruction to the assembler. 3. The ORG (origin) is an example of pseudo instruction. 4. It is not possible to use ORG more than once in a program. Select the correct answer using the code given below.
With reference to 8085 microprocessor, which of the following statements are correct? 1. The DAD instruction adds the contents of the specified register pair to the contents of the DE register pair 2. The program counter is an instruction pointer 3. Whenever an instruction uses the HL pointer, the addressing is called indirect addressing. 4. HL register pair is also called data pointer
The instruction given to a computer system is loaded into the Instruction Register. The processor interprets the instruction and performs the required action. In general, these actions fall into four categories. Which of the following actions is not a part of these four categories? 
With reference to 8085 microprocessor, which of the following statements are correct? 1. INR is 1-byte instruction 2. OUT is 2-byte instruction 3. STA is 3-byte instruction
For a pipelines CPU with a single ALU, consider the following : A. The j + 1st instruction uses the result of jth instruction as an operand B. Conditional jump instruction C. jth and j + 1st instructions require ALU at the same time Which one of the above causes a hazard?
A __________ occurs while forgetting to enter an instruction, or entering the instruction in wrong order.
The CAI (Computer-Assisted Instruction) technique based on programmed instruction is __________
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
Which of the following memory-based addressing mode satisfies the below statements? 1. The address of the memory location that holds the operand is included in the instruction. 2. The effective address is the address part of the instruction. 3. It is used to access the static variables.