Bissoy.com
Doctors Medicines MCQs Q&A

In a half wave rectifier, the input sine wave is 200sin200 ᴨt Volts. If load resistance is of 1k then the average DC power output of half wave rectifier is __________

In a half wave rectifier, the input sine wave is 200sin200 ᴨt Volts. If load resistance is of 1k then the average DC power output of half wave rectifier is __________ Correct Answer 4.05W

The equation of sine wave is in the form Em sin wt. On comparing Em = 200 Power = Em2/ ᴨ2RL = 200/ ᴨ2x 1000.

Related Questions

In a center tapped full wave rectifier, the input sine wave is 200sin50 ᴨt. If load resistance is of 1k then average DC power output of half wave rectifier is __________
In a half wave rectifier, the input sine wave is 250sin100 ᴨt Volts. The output ripple frequency of rectifier will be __________
In a half wave rectifier, the input sine wave is 200sin100 ᴨt Volts. The average output voltage is __________
In a half wave rectifier, the sine wave input is 50sin50t. If the load resistance is of 1K, then average DC power output will be?
Consider the following statements. It converts the positive half cycle of the sinusoidal wave of the input to the pulsating DC output signal. It converts the positive half as well as negative half cycle of the sinusoidal wave of the input to pulsating DC output signal. Which of the following statements is CORRECT about half-wave rectifier?
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
The circuit shown below has the following parameters: V1 = 8 Volts V2 = 6 Volts Vs = 10V/√2 (rms) Voltage drop across D1 & D2 = 0.7 Volts At the load (R), the peak value in the positive half cycle will be
The circuit shown below has the following parameters: Voltage drop across D1 & D2 = 0.7 Volts V1 = 8 Volts V2 = 6 Volts Vs = 10V/√2 (RMS) At the load (R), the peak value in the negative half cycle is
In a center tapped full wave rectifier, the input sine wave is 250sin100 ᴨt. The output ripple frequency of rectifier will be __________
In a half wave rectifier, the sine wave input is 200sin300t. The average value of output voltage is?